The exterior of the encrusting machine, the filling section, the screw, the cylinder, the surface, the filling, the pump, the elbow and the outlet, and the interface components. Do not clean the housing and screws with metal or hard objects. The water temperature should not be too high, about 40 ℃. Carefully load and unload the parts. Parts easy to roll shall be placed on the rag to avoid falling and damage. Turn on the electrical control box on the main power switch of the packaging filling machine to enter the home page, click the home page touch screen display (click) to stop the transmission switch, then click the load to start, use the electronic scale to correct the filling amount, if the required weight, click (decrease) until the required weight is reached, and then click (increase) until the required weight is reached. Debug the number of skins and the number of blanks in the same way. Click (Save) the number to save this set of data for next use.
Post time: Dec-23-2022